Proxima Ultralight S520 Bedienungsanleitung PDF herunterladen (Seite 18)

ENGLISH-17

MMAAIINNTTEENNAANNCCEE ((ccoonnttiinnuueedd))

ENGLISH

Replacing the Lamp

1. Switch the projector OFF, remove the power cord from the

power outlet, and wait at least 45 minutes for the unit to cool.

2. Prepare a new lamp.

3. Check that the projector has cooled sufficiently, and gently

turn it upside down.

4. Loosen the two screws as shown in the diagram, and remove

the lamp cover.

5. Loosen the one screw, and gently remove the lamp while

holding the grips. Touching the inside of the lamp case may

result in uneven coloring.

6. Install the new lamp and tighten the one screw firmly. Also

steadily push the opposite side of the screwed lamp into the

unit.

7. Replace the lamp cover in position and tighten the two

screws firmly.

8. Gently turn the projector right-side up.

* Ensure that screws are tightened properly. Screws not

tightened fully may result in injury or accidents.

* Do not use the projector with the lamp cover removed.

Resetting the Lamp Timer

Reset the lamp timer after replacing the lamp. When the lamp has been replaced after the LAMP

indicator is red, or the CHANGE THE LAMP message is displayed, complete the following

operation within ten minutes of switching power ON. The power will be turned off automatically in

over 10 minutes.

1. Switch power ON, and press the TIMER button on the remote controller, or the RESET button

on the control panel, for approximately three seconds. The ‘LAMP xxxx hr’ message will appear

on the lamp timer on the bottom of the screen.

2. Press the MENU button on the remote controller, or the RESET button on the control panel,

while the lamp timer is displayed. The ‘LAMP xxxx

→ 0 ■ CANCEL’ message will then

appear.

3. Press the and select 0, and wait until the timer display is cleared.

Do not reset the lamp timer without replacing the lamp. Reset the lamp timer always when

replace the lamp. The message functions will not operate properly if the lamp timer is not

reset correctly.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 36 37

Keine Kommentare

Proxima Ultralight S520 Bedienungsanleitung Seite 18